Project

General

Profile

Bug #4357

Workflow Run Manager does not mark last failed execution red

Added by Oliver Soong over 9 years ago. Updated almost 9 years ago.

Status:
Resolved
Priority:
Normal
Category:
workflow run manager
Target version:
Start date:
08/31/2009
Due date:
% Done:

0%

Estimated time:
Bugzilla-Id:
4357

Description

The workflow run manager is supposed to highlight failed executions in red. If I run a workflow and it fails, though, it is not highlighted. If I run it again, then the first failure is highlighted but not the second. If I run it again, then the first two are highlighted, but not the third. If I close and re-open Kepler, all failures are highlighted. It seems that highlighting is not updated after an execution.


Related issues

Blocks Kepler - Bug #4230: problem associating errors with particular executionResolved07/08/2009

History

#1 Updated by Derik Barseghian over 9 years ago

should be fixed by r20571 for the most part.
Leaving open since might still be a problem when using PN - see bug dependency.

#2 Updated by Derik Barseghian almost 9 years ago

Can't get this to occur anymore, closing.

#3 Updated by Redmine Admin about 6 years ago

Original Bugzilla ID was 4357

Also available in: Atom PDF